Varta V-AVD22T Bedienerhandbuch PDF herunterladen (Seite 6)

AVD22T

Installation

• The unit is designed for 12V DC, negative ground operation system only. Before installing the unit, make sure

your vehicle is connected to DC 12V negative ground system.

• Be sure to connect the color-coded leads according to the diagram. Incorrect connections may cause the unit

to malfunction or damage the vehicle’s electrical system.

• Be sure to connect the speaker (-) leads to the speaker (-) terminal. Never connect the left and right channel

speaker cables to each other or to the vehicle body.

• Make sure all the connections are completely correct before turning on your unit.

• When replacing the fuse(s), the replacement must be of the same amperage as shown on the fuse holder.

• Do not block vents or radiator panels. Blocking them will cause heat to build up inside and may result in fire.

• After completing the installation, please remove the front panel at first, and then press RESET button on the

base with pointed object (such as ball-point pen) to set the unit to initial status.

• Use only the parts included with unit to ensure proper installation. The use of unauthorized parts can cause

malfunction.

• Consult with your nearest dealer if installation requires the drilling or other modifications of the vehicle.

• Install the unit where it does not interfere with driver’s actions and cannot injure the passenger if there is a

sudden stop, like an emergency stop.

• The semiconductor laser will be damaged if it overheats, so don't install the unit in hot place, for example,

near a heater outlet.

• If installation angle exceeds 30 from horizontal, the unit might not give its optimum performance.

• The cords must not cover up the area shown in the figure below. This is necessary to allow a normal heat

exchange of the unit.

Downloaded from Caradio-Manual.com Manuals

1 2 3 4 5 6 7 8 9 10 11 ... 38 39

Keine Kommentare

Varta V-AVD22T Bedienerhandbuch Seite 6